First project at North Fork Country Club. Extended the blade on a SandPro past the wheels, and the extensions are able to be adjust their angle.

Winter project on the Toro 1250 Sprayer wrapped up. Complete refurbish on the booms, including removing a section of rot and welding a new tube in place, sandblasting, painting and overall touch up.

Doing a clutch job on a Case D40. The new clutch did not come with an alignment tool. Finding one online was tough and my dealer is an hour and a half drive one way. Took some measurements from the new parts, modeled, and 3D printed one up.

Been having issues with our diesel MultiPro 5800 overheating after about 3 hours of use. The engine compartment was getting to hot. Put 2 fans in the back side of the compartment, one pushing air and one pulling air. Hooked up to the fuse block so it’s powered by the ignition.