Mechanical Engineering Student / 3D printing enthusiast
Joined May 2018
- Tweets 213
- Following 240
- Followers 358
- Likes 1,293
70 Photos and videos
Photo dump of the #PrusaXS. Still a few things to do, including an all new extruder design (still using the @E3DOnline #Revo of course!) 1/X
40
31
241
27,109
I based the frame off the photos of the Core One from Prusa's site, but I didn't and don't have one to compare to. The parts were stainless steel cut, bent, and painted by @sendcutsend. I only was able to order the CoreXY part as the rest was just too expensive to get. 4/5
1
2
7
389
Unfortunately, the project is dead as I didn't feel like spending so much on the rest of the frame, though I did design the Z axis (using only one Z motor from the Prusa Mini) that used belts to transmit the rotation to the front two T8 rods, along with most of the enclosure. 5/5
6
347
M3 Bolt retweeted
20 Jun 2024
Almost there, #Nitehawk -36!
Repost/Like, we will randomly selected 3 persons (Sorry US only) to give away for early taste. (till Friday)
15
76
148
10,585
Does anyone know what type of connector this is on the @BambulabGlobal A1/A1 Mini tool head board? It's where the hotend plugs into
1
2
5
750
Have there been any confirmed @Sovol3d SV08 retail units shipped in the US? #3DPrinting
2
391
Are there any #Voron Stealthburner tool boards that would work with the Einsy RAMBO? I'm not sure if the @BigTreeTech boards would work.
Extruder wiring has a short it again, and I'm looking to simplify the wire run with one harness #3DPrinting
4
1
12
1,737
A hole in the clouds of PA rolled by at just the right time to see the eclipse! #Eclipse2024 #SolarEclipse2024
1
501