Joined September 2009
97 Photos and videos
Ihr nutzt schon auch (self hosted) changedetection.io um so schnell wie möglich zu wissen, wann endlich richtiges @init7 Internet bei euch möglich ist?#640MUE 🤓
7
192
Finally found some time to upgrade and cleanup my homenet/lab. #Unifi Switch/AP, 10gbit #opnsense on gowin r86s (ready for init7), #proxmox wirh some #k3s vms. DIY Rack
1
11
1,337
Auto von 30% auf 80% .. ✅ #emobility #pv #solar
6
264
Sucht jemand ein neues Auto? Meines wäre zum Verkaufen #auto #occasion autoscout24.ch/de/d/11352526

92
Sebastian Plattner retweeted
10 Jan 2024
Auch wir sind aus dem Winterschlaf erwacht und laufen trotz der ❄️ Temperaturen wieder heiss ;) Wir freuen uns über unsere Besucher der @Swisscom im #Terraform Basics Training. Mehr dazu hier: acend.ch/trainings/terraform… #NeverStopLearning #LearnCloudNative
1
2
144
Finally hooked up a Logic Analyzer to my Oekoboiler Water Heater and sniffed the UART/USART between the controller/display board and the inner control board. Seems to be some sort of Modbus, but can't really make sense of it. "
1
183
"64 41 3F B6 86 DF 2D 0B 26 BE C6 11 06 F9 79 11 56 B0 AB FB 32 7F 33 81 89 C3 91 63 A0 78 35 E8" 35 E8 is CRC-16 checksum used by Modbus. 64 should be the address and 41 the function. But this is a unkown function. And I cannot derive something with the data.
1
91
this is all to get rid of this x.com/SebaPlattner/status/16… although it works still quite well :)

How to make a stupid water boiler (a small bit) smarter. a ESP32 camera with @esphome_, some Pyhton Pillow magic and @home_assistant
92
Learning some new skills🤓#diy #pcb. It didn't blow up, so I did something right :) saw the CH340K on my laptop. But couldn't yet program the #esp32. So far found 1 schottky diode the wrong way around, the 5V-3V3 LDO have 5V&3V3 pins connected. Hopefully just a soldering problem?
1
4
221
Got that board up & running. A 2nd diode was also the wrong way some solder bridges that needed to be fixed. @esphome_ is installed, 2 GPIO expander (I2C) are also working (hence the relays). Next: testing POE & the AC Input (PowerSupplyModule is not yet soldered onto the board)
72
Sebastian Plattner retweeted
30 Jun 2023
This week we had the pleasure to conduct our #Container & #Kubernetes Basics training for @PostFinance. More information about our #CloudNative trainings can be found here: acend.ch/en/trainings/ #LearnCloudNative #NeverStopLearning
3
6
211
Feature Request an @_solarmanager da ich leider aktuell immer wieder Internet Ausfall habe, siehts bei mir immer wieder so aus. Ein lokales Caching der Daten wäre noch nice, welcher dann die Daten nachsendet. Zum Glück zählen die kWHs da ja trotzdem 😎😉 auch wenn nicht gemessen
3
6
671
hallo @_solarmanager ich glaube eure Doku external-web.solar-manager.c… hat da einen Fehler. "Optimization On" ist 0 und "no Control" ist 1 für heat pump.
1
2
198
und vielleicht hilft es jemandem, das Feld im info/sensor JSON heisst heatPumpMode, gesetzt wird es aber als chargingMode via control/heat-pump #Servicetweet ;)
1
118
Kann ein PV Wechselrichter ein Kabel Model beintrachtigen? Ist da etwas bekannt? Wir hatten nun mehrfach über Mittag (bei sonnigem schönen Wetter sprich Leistung am höchsten) Internet Ausfall, Modem hat Signal verloren. Hast evtl du @technikblog_ch schon Mal so etwas gehört?
4
3
10
3,401
Sebastian Plattner retweeted
9 May 2023
Die Ruhe vor dem Sturm... Wir sind ready für das erste #Training in unserer neuen Location an der Sickingerstrasse in Bern. Wir freuen uns euch dort zu empfangen! Auch interessiert? 👉 acend.ch/trainings/ #LearnCloudNative #NeverStopLearning
1
4
10
302
PV-Daten April 2023 Produktion: 1568 kWh Autarkie: 48.3% Eigenverbrauch: 17% Relativer Ertrag: 105.8 kWh/kWp, 14.82kWp #pvbuddies
4
186
Good morning from #KubeConEU, last day already @KubeCon_ @puzzleitc @acendch
2
169
5
169