📢 500,000 $PIEVERSE Red Packet Campaign Airdrop ~ part 2 @pieverse_io launched the OKX red packet campaign with where users can send/receive packets to climb the leaderboard for bigger rewards 🤝 If you're new, first complete the setup guide (Part-1): x.com/smolwyne/status/205840… Now here’s how to send & receive red packets 👇 🔗 go to: tinyurl.com/u3w9htzb 1️⃣ bridge funds to x layer you’ll need: – $USDT0 on Xx layer – small amount of $OKB for gas Steps: – open rabby wallet – bridge ETH/USDT from arbitrum or base to x layer – bridge small $OKB amount for gas fee (~$0.1–$0.2 enough) – then bridge your $USDT0 (bridging may take 10–20 mins) 2️⃣ deposit into your claw – open Pieverse web – open your claw → manage – copy your deposit address – send $USDT0 there from rabby – wait & refresh You can withdraw anytime later 🤝 3️⃣ send red packets – open the pieverse telegram bot use this prompt: "send a USDT0 red packet to .pie for USDT0 on x layer." Example: send a $USDT0 red packet to smolwyne.pie for 10 $USDT0 on X Layer. – send the prompt in bot – wait for confirmation – done 👀 4️⃣ claim received packets – If someone sends you packets, the TG bot will notify you – use the claim command from the bot: "help me claim all pending redpackets" – open your claw & check balance ⚠️ claim in 24hours, otherwise it’s will expired You can: – withdraw funds – or resend packets to others 5️⃣ how to rank higher? – send packets to UNIQUE addresses – avoid repeatedly sending same address ⚠️ If you don’t have friends to exchange with, you can temporarily use my IDs: – smolwyne.pie (send today) – ishika.pie (send todey) 6️⃣ check leaderboard – open okx campaign page – check leaderboard section Campaign may run for around 10 more days 👀 7️⃣ withdraw funds after finishing: – withdraw $USDT0 back to rabby – bridge back from x layer → arbitrum/base – all done ✅ So basically: send/receive packets → rank up leaderboard → become eligible for bigger $PIEVERSE rewards. If anything is confusing, comment below 👇